Skip to content
Contact Support
  • There are no suggestions because the search field is empty.

Configure devices to connect to the AltoCommand server

With AltoCommand release 4.x and newer, the hostname or IP address of the AltoCommand server is set on the AltoPlex distribution node (DN) or point-to-point device, or on the the K60 radio. AltoPlex client nodes (CNs) inherit the AltoCommand server configuration from the DN to which they are linked.

Configure an AltoPlex or K60 device to connect to AltoCommand

With AltoCommand 4.x and newer, AltoPlex devices must be at release 3.9.1 or newer. K60 radios must be at 3.21.230 or newer. Other Gen2 devices are not supported.

  1. Log into the WebUI for an AltoPlex DN or point-to-point device, or for a K60 radio. See the device documentation for instructions.
  2. In the WebUI for the device, click the Admin tab.
  3. In the Configuration section, for AltoCommand server, type the fully-qualified domain name or IP address of the AltoCommand server.
  4. Click Save Changes.

After the connection to the AltoCommand server has been configured on the device, the device sends an approval request to the AltoCommand server. A user with admin permissions on the AltoCommand server must accept the request, which will open a reverse tunnel for communication between the server and the radio.

After a device has been configured to request a connection to AltoCommand, it may take up to a minute for the device request to be displayed in the AltoCommand WebUI.